How to Mount Studio Lights with Gorilla Clamp
By ephotoinc | Published: 2026-10-30
Category: How-to Guides
Learn how to securely mount studio lights and accessories using a gorilla clip clamp with a 1/4-inch stud. Step-by-step guide with common mistakes to avoid.
Quick Answer
To mount a studio light with a gorilla clip clamp, attach the clamp to a sturdy surface, then screw the light or accessory onto the 1/4-inch stud. Make sure the stud is fully threaded and the clamp is tight before releasing the light.
Why a Gorilla Clip Clamp Works for Studio Lights
A gorilla clip clamp gives you a quick, secure mounting point almost anywhere—on a table edge, shelf, or rigging bar. Its aluminum body and 5/8-inch stud with a 1/4-inch thread let you attach a wide range of studio lights and accessories without a dedicated light stand.
The main trade-off is weight capacity. These clamps are best for small monolights, LED panels, or accessories, not heavy studio strobes. Always check your light's weight and keep the clamp close to the surface for better stability.
Step-by-Step Mounting Guide
- Check the clamp and surface: Inspect the gorilla clip clamp for any damage, and make sure the surface you plan to attach it to is clean, flat, and can support the weight of your light. A common mistake is clamping to an uneven or flimsy surface, which can cause the clamp to slip or the light to tilt. Test the clamp's grip by pulling on it before attaching the light.
- Attach the clamp securely: Position the clamp on the surface and tighten the clamp's screw until it holds firmly. Avoid over-tightening, which can damage the surface or strip the clamp's threads. A common mistake is not tightening enough, leading to a loose mount. Give the clamp a gentle shake to confirm it's secure.
- Mount the light on the 1/4-inch stud: Screw the studio light or accessory onto the 1/4-inch stud. Turn it clockwise until it's snug, but don't force it. A common mistake is cross-threading, which can damage the threads and make the mount unstable. If the light doesn't thread smoothly, remove it and try again rather than forcing it.
- Adjust and lock the angle: Once the light is attached, adjust the angle using the clamp's ball joint or swivel (if available). Tighten the locking knob to hold the position. A common mistake is leaving the locking knob loose, causing the light to droop over time. Check the angle and tightness after a few minutes to ensure it holds.
Product Facts
- Photography Video Gorilla Clip Clamp Studio Monolight Mounting 1/4" Stud with CLAMP by ePhoto INC A280: The Photography Video Gorilla Clip Clamp is made of aluminum with a 5/8-inch stud and 1/4-inch thread. This lets you mount most small studio lights and accessories that have a standard 1/4-inch socket, giving you a secure connection without adapters.
Photography Video Gorilla Clip Clamp Studio Monolight Mounting 1/4" Stud with CLAMP by ePhoto INC A280
